How do I let audio device in "Sounds and Audio Devices"?

Peter Lin

Guest

Posts: n/a

04-05-2008

How do I let audio device in "Sounds and Audio Devices"?

Now, I have two pins. One input audio pin, and One output audio pin.
There are in one Filter.
I create one node in the Filter, and I create two connection to connect them.
But "Sounds and Audio Devices" does'nt show my audio device.

Is need special condition?
thanks.

« do not use CM_xxx function call | Re: ntstrsafe.h "No such file or directory in Wndows DDk 2600" ???? »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
"No Audio Devices Detected" problem	Phil	Windows Vista General Discussion	2	08-30-2008 07:16 AM
Dell and "no audio output device installed" after Vista upgrade	silksoul4u	Windows Vista Hardware	6	08-13-2008 11:04 AM
Microsoft Driver for "Legacy Audio Devices"	Andrew Fiddian-Green	Windows Vista Hardware	0	08-28-2006 04:11 PM
cross mapping "USB audio device" to specific USB device descriptor or How to retrieve USB device serial number		Windows Vista Drivers	0	07-21-2006 07:13 PM
cross mapping "USB audio device" to specific USB device descriptor.		Windows Vista Drivers	0	07-21-2006 06:40 PM