Solution of constanly boots - whit EventId 1003 & catogorie (102)

This is after install the SP2 of Xp and you have spontanesly boots !!

This is an solution whith some consequents and must therefore only used if
you have constantly spontanesly boots whith an result of and EventId 1003
whit catagorie (102) whit the problem of 0x8E & patameter 0x00000005 this is
an result whith the results of an STATUS_ACCESS_VIOLATION

See for the solution of this problem the artikel >>
http://www.microsoft.com/technet/pro.../sp2mempr.mspx

you must TURN OFF the DEP and you can only this doing in the BOOT.INI by the
followling setting /NoExecute=AlwaysOff

----------------------------------------------------------
An little quoting of the artikel for resolving this problem


The four system-wide DEP configurations are controlled through boot.ini
switches. The Boot.ini settings are as follows:

/noexecute=policy_level

where policy_level is defined as AlwaysOn, AlwaysOff, OptIn, or OptOut.

Any existing /noexecute setting in the Boot.ini file is not changed when
Windows XP SP2 is installed or if a Windows operating system image is moved
across computers with and without hardware-enforced DEP support.

During installation of Windows XP SP2, the OptIn policy level is enabled by
default unless a different policy level is specified in an unattended
installation. If the /noexecute=policy_level setting is not present in the
boot entry for a version of Windows which supports DEP, the behavior is the
same as if the /noexecute=OptIn option was included.

--------------------------------------------------

Best regards

Ronald
Netherlands