Windows driver debugging using 1394

Hello all !!!

I am new to windows device driver development... I want to setup the
remote debugging using 1394 fireware card. I followed the steps in the
document DW04001_WINHEC2004. In the host side I installed the
debugging tool (version 6.9.3.113). But as discussed in the document
when i started WinDbg wih 1394 enabled in channel 10 it was not
installing two drivers ,it was installing only one driver - 1394
windows debug driver (kernel mode) (1394kdbg.sys). It was not
installing 1394 windows debug XP driver, and the Windbg application
was showing the message "Waiting to reconnect".

I followed the same steps in the document in target side and restarted
the target machine.. But it was not connecting to the host.. I used
the 6-6 pin to connect host and target.

Anyone could you please help me... is it necessary to install 1394
windows debug XP driver in host side to make it work ???..

Both Host and Target machine is running Wondows XP SP2.

Could you please give your valuable suggestion for to make it
work ????

Thanks in advance
Biju