5381 X64 Vista Install Failure

Discussion in 'Windows Vista Installation' started by The Primate, May 13, 2006.

  1. The Primate

    The Primate Guest

    I am installing from XP Pro 64 via a mounted ISO image. I cannot burn a
    disk since I do not have a dual-layer dvd.

    Install starts fine but while copying files suddenly reboots. I am left
    with a $WINDOWS.~LS directory on the partition of about 3.5GB. Parition
    size is 22GB . Any ideas? The only thing I can think of is to remove all
    items I can from memory and the tray before starting. Perhaps another iso
    download?
     
    The Primate, May 13, 2006
    #1
    1. Advertisements

  2. Hmm.. it should work as a mounted image - I tend to do this to save DVD's.
    However try copying over the files from the virtual drive mounted onto a
    seperate folder on the harddrive, and see if that helps :eek:)

    --
    Zack Whittaker
    » ZackNET Enterprises: www.zacknet.co.uk
    » MSBlog on ResDev: www.msblog.org
    » Vista Knowledge Base: www.vistabase.co.uk
    » This mailing is provided "as is" with no warranties, and confers no
    rights. All opinions expressed are those of myself unless stated so, and not
    of my employer, best friend, Ghandi, my mother or my cat. Glad we cleared
    that up!

    --: Original message follows :--
     
    Zack Whittaker, May 13, 2006
    #2
    1. Advertisements

  3. The Primate

    The Primate Guest

    My own suggestion worked!
    Removing items from the tray and memory worked, three previous installs
    had all failed as noted.

    --
    AP
     
    The Primate, May 14, 2006
    #3
  4. Andre Da Costa [Extended64], May 14, 2006
    #4
  5. The Primate

    paolo besser Guest

    The Primate ha scritto:
    You don't need a dual layer DVD. Just burn on a plain 4.7 GB DVD the
    version you prefer (x86 or x64) loading disc image in your burning
    software, then use the DVD directly.

    p.bes
     
    paolo besser, Jun 1, 2006
    #5
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.