Can send email to any domain except email domain

Discussion in 'Windows Small Business Server' started by Ed Podowski, Jul 18, 2005.

  1. Ed Podowski

    Ed Podowski Guest

    I remember a known issue with SBS 2003, but I do not remember the KB Article.
    I needed to add the email domain someplace so exchange knew where to send
    the message to someone, for example, @clientdomain.com. This person is not
    in Active Directory. I want to say it was to resolve a DNS issue, but this
    may not be correct.

    New install, can receive email through pop3 connector and can send email to
    [email protected], but we can not send an email to someone at this client's
    email domain.

    For example: We can send email to a user listed in active directory at
    clientdomain.local, but when we send a message to say
    which is not a user in active directory the system
    immediately returns a message that says:

    Your message did not reach some or all of the intended recipients.

    Subject: Test Email
    Sent: 7/18/2005 1:58 PM

    The following recipient(s) could not be reached:

    on 7/18/2005 1:58 PM
    The e-mail account does not exist at the organization this
    message was sent to. Check the e-mail address, or contact the recipient
    directly to find out the correct address.
    <clientdomain.com #5.1.1>

    End of message-------------------

    The KB Article was perfect [when followed] in resolving this issue. If only
    I could remember.

    Thank you, I'll be right back; went looking for more memory! :)
     
    Ed Podowski, Jul 18, 2005
    #1
    1. Advertisements

  2. Ed Podowski

    Matt Gibson Guest

    Matt Gibson, Jul 18, 2005
    #2
    1. Advertisements

  3. Ed Podowski

    Ed Podowski Guest

    Thank you Matt! Worked Great!

    I didn't remember all those steps, [but then again, I didn't remember the KB
    Article.] :)

     
    Ed Podowski, Jul 18, 2005
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.