CMAK vpn add static route problem

hi!

i have created a text file which contains following line:
ADD 192.168.0.0 MASK 255.255.255.0 default METRIC default IF default

then i create service profile, define a routing table with the above text
file by CMAK. but when i try this profile, it won't add static route what i
want.

did i miss something? please advise. thx in advance!!!

 

route ADD 192.168.0.0 MASK 255.255.255.0 ip_of_the_gateway_to_network
(example 192.168.1.0)
If you leave default settings you can leave out the remaining part of the
command.

 

at before i just think "default" means "will detect vpn client IP
automaatically"

would you please advise me, should i use ip_of_the_gateway_to_network
instead of "default", ex. 192.168.1.1 ? but it is too trouble for me to
config different static route for different user.

did i missunderstand what you mean, please advise. thx!


because vpn clients get their IP via DHCP,

 

Hi!
I would certainly recommend you to use "default" as your interface
identifier. A Client normally changes IP after each logon, so it's hard to
use that.


I recently was quite puzzled by the static routing functions when building a
CMAK but i became aware of a real No-no that might help you:
1. Make sure you have the "use this connection as default gateway" option
ENABLED in the CMAK config. This sorted out a lot of my problems. Use
REMOVE_GATEWAY in the routes.txt or whatever you called it instead. Check out

http://technet2.microsoft.com/WindowsServer/en/Library/cc37da78-1138-4186-9abb-32b31ca8eac41033.mspx

where there is more info.