I disabled an user, and then re-enable this user later on. But that user cannot access her Outlook E

Discussion in 'Active Directory' started by Joe, Mar 30, 2005.

  1. Joe

    Joe Guest

    ....when I sent her a test e-mail, I got this kind of bounce back message:

    Your message did not reach some or all of the intended recipients.

    Subject: test
    Sent: 3/29/2005 4:16 PM

    The following recipient(s) could not be reached:

    This Useron 3/29/2005 4:16 PM
    The message reached the recipient's e-mail system, but delivery
    was refused. Attempt to resend the message. If it still fails, contact
    your system administrator.
    <mailserver.mycompany.net #5.2.1>


    Here are the servers info:

    Domain Controller: Windows Server 2003
    Exchange Server: Windows Server 2003+Microsoft Exchange 2003 Enterprise

    Thank you for your help.
     
    Joe, Mar 30, 2005
    #1
    1. Advertisements

  2. Wait until the information about this re-enabled user replicates to the GC
    used by Exchange server, and then wait again for Exchange's NSPI (might be
    wrong with abbreviation here, some sort of directory services proxy service
    for accessing DS data) re-reads it from GC.
     
    Dmitry Korolyov [MVP], Mar 30, 2005
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.