Install on Asus P4P800, SATA non-RAID drive

Discussion in 'Windows Vista Installation' started by Allen French, Jun 8, 2006.

  1. Allen French

    Allen French Guest

    I am installing from DVD to 2nd partition with XP on 1st partition. Setup
    runs ok until the first reboot, then all I get is a blank screen and blinking
    cursor. If I install XP on the 2nd partition and then upgrade to Vista, it
    works fine. I also loaded the Asus P4p800 CD during setup, but it didn't find
    any needed drivers.
     
    Allen French, Jun 8, 2006
    #1
    1. Advertisements

  2. Allen French

    Allen French Guest

    Follow-up: I experimented with options in the bios setup, and was able to
    install the x86 Vista beta 2 by changing the IDE Configuration from Enhanced
    mode for S-ATA to Compatibility mode for P-ATA. After the first boot, Vista
    continued successfully.
     
    Allen French, Jun 14, 2006
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.