Scanner Canon Canoscan 3000f on 64bit Vista

Discussion in 'Windows Vista Hardware' started by SandyX, May 30, 2007.

  1. SandyX

    SandyX Guest

    There are no drivers for my scanner as it is not compatible with 64bit Vista.
    Does this mean my scanner is now redundant? Hey, I like this scanner!! Is
    there a solution or is it now a pedal car?
     
    SandyX, May 30, 2007
    #1
    1. Advertisements

  2. SandyX

    freddy Guest

    SandyX,

    The following site sells Vista compatible scanner drivers/software for over
    700 different models of scanners:

    http://www.hamrick.com/

    The manufacturer of my scanner didn't support my scanner in Vista either, so
    I purchased the software from that site for $40. It works well, and I'm
    still using my scanner in Vista. You need to check that your model is
    supported by them and then decide whether $40 is the way you want to go.
     
    freddy, May 30, 2007
    #2
    1. Advertisements

  3. SandyX

    tektaktyks Guest

    i was able to install canoscan 3000f drivers on windows 7 x64 under the
    virtual "xp mode" and i am able to use it just like before on 32 bit
    system,hope it helps
     
    tektaktyks, May 27, 2009
    #3
  4. SandyX

    Cahponnet Guest

    I am totally new to Vista, so I would really appreciate som
    explanations on how to install the driver under the virtual "xp mode"

    :
     
    Cahponnet, Oct 7, 2009
    #4
  5. SandyX

    Tae Song Guest

    That's Windows VII not VIsta.
     
    Tae Song, Oct 8, 2009
    #5
  6. SandyX

    Cahponnet Guest

    That's Windows VII not VIsta.

    Oh I see... Sorry
    «:
     
    Cahponnet, Oct 8, 2009
    #6
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.