Unable to change from Mixed mode to native mode.

Discussion in 'Active Directory' started by Alan, Dec 3, 2003.

  1. Alan

    Alan Guest

    When attempting to change from mixed mode to native mode it states that it
    happened successfully and that it could take some time to propagate etc.,
    however a subsequent message states either, a.) The following active
    directory error occurred: a device attached to the system is not
    functioning, or b.) The following active directory error occurred: A global
    group cannot have a universal group as a member. Then if I go back into the
    properties for the domain it shows mixed mode, the change never takes. Any
    ideas or suggestions would be very welcome. Please reply to this post.

    Thanks,

    Alan
     
    Alan, Dec 3, 2003
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.