Vista Wont Boot Unless in Last Known Good Configuration

Discussion in 'Windows Vista General Discussion' started by Luke Pickard, May 29, 2006.

  1. Luke Pickard

    Luke Pickard Guest

    I've seen one other guy (zephyrhills) who was having the same problem as I.
    I have installed vista onto a second partition and when I boot my pc it gives
    me the screen to choose OS. Upon the first time choosing Vista it worked
    great!!! I wanted to restart to xp (and did) then went back to vista (after
    making no changes). It told me that it didn't shut down correctly and gave
    me the choicies (safe mode... last known good config... normally) so i chose
    normal. It started to boot, but then hung up and eventually my monitor went
    off because of no signal from the pc. I'm using DVI btw. So anyway, i
    restart again and do last known good config. Works great!!! so i install the
    drivers thinking this is why, and restart to vista, same thing!!! Wont boot
    normally, and only works with last known config. When i choose last known
    good config, it reverts back to the pc's original state (no drivers or
    anything) so i'm in this non stop loop. Any help would be apprecatiated.
    Specs below:

    A8n SLI deluxe mb = amd 64bit 3500+ SATA 190 gig maxtor hard drive, 1 gb ram.

    thanks
     
    Luke Pickard, May 29, 2006
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.