Zone Alarm

Discussion in 'Virtual PC' started by Bill Wallace, Sep 9, 2004.

  1. Bill Wallace

    Bill Wallace Guest

    I have a NAT router connected to Internet dishing out 192.168.0.x addresses.
    I've set up a virtual network that has an intranet of DHCP clients on a Local
    Only network. One of the VMs is W2003 with the Local Only NIC static on
    192.168.3.1 and a second virtual NIC using my Host's Internet NIC. This VM is
    set to use RRAS Nat routing. All VM clients pick up a 192.168.3.x address ok.

    Zone Alarm is installed on the host and all VMs. I have added the subnet
    192.168.3.0 as a trusted zone to all systems and they also trust the
    192.168.0.0 subnet.

    With Zone Alarm switched on, on any system, this setup fails. When off, it
    all works sweetly.

    Any ideas as to what configuration Zone Alarm might require to make it work?

    Bill Wallace
     
    Bill Wallace, Sep 9, 2004
    #1
    1. Advertisements

  2. Bill Wallace

    Bill Grant Guest

    A pretty remote connection to VPC!
     
    Bill Grant, Sep 10, 2004
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.